Starbond 10 oz. XL CA Glue Accelerator Spray - Instantly Dries Cyanoacrylate Super Glue – No Whitening, Controlled Application

One spritz from this will almost instantly harden up any CA or super glue applications. For me it's handy to apply to a mating surface when gluing two pieces of anything together. You don't have to hold your repairs even for the typical 30 seconds that you do when not using an accelerant. I do much wood working and this also helps set up CA glue when using it for a quick fill in pin knots, small cracks and the like. It does not diminish holding power. And when dry (a few seconds) you can sand it to blend in. Very helpful and keeps for years.

I would definitely recommend this glue accelerator spray when using it with Starbond CA Brown Glue. It sped up my project quite a bit. I used it on knots in a 1 3/4" thick oak board. It was easy to layer it with glue then spray it with the accelerator, and repeat. Before I knew it I was ready to sand. This was a good find.

Works exactly as advertised with Starbond CA glue. I used this on some PLA prints and love the results.

I've used two can of this in the past, albeit smaller cans. The 10 oz. can seemed to leave a white powdery residue un my work area, also the odor seemed to linger in the area as well as on the items in my crafting area. It says the atomizer is different and maybe that is part of the cause. Maybe I can use less of the product now. Still struggling to find a balance.

I was using GluBoost GluDry because it was the only thing I could find that didn't make hard white nodules or fog the finish. I decided to give this a try and found that it works just as good as GluDry for a better price. I use Starbond CA glues to finish entire guitars and necks. If you're just patching dings with CA glue on a nitrocellulose finish DO NOT USE this accelerator. It contains acetone (always read the ingredients and test on a small, inconspicuous area). Actually, if you're just patching little dings with CA glue, why do you need an accelerator? The thin stuff cures in about 10 seconds.

I use this with other starbond products. Filling cracks on wood products. It works fast so I don’t have to wait for the glue to dry by itself before sanding.

Great stuff. I wouldn’t run my shop without it. Use it sparingly it doesn’t take much. I will buy again.

Works great

Works as advertised, I like it better than the non-aerosol versions from other brands.

Works as good as any accelerator, just have to look for the best price.

It's glue..

Works as described. Perfict for my wood projects.

if you need to glue to work fast this is it