Monroe SC2962 Magnum Steering Damper

Fit with no problem

Deu td ok.

Se ve bueno, solo que si lo comparo en el que tenía se siente igual, no tiene mucha fuerza, espero que me dure

Good Product

My 2001 Grand Cherokee needed the track bar, steering bar, drag link, tie rods (4), sway bar links (2) and the stabilizer shock replaced so after much researching and reading I decided on the Moog product line with the Monroe Stabilizer Shock and SA1997 Cover. My two major deciding factors were: 1. Quality 2. Price Moog exceeded both of these. I really liked that the bushings were already pressed, or install, in place on the replacement parts. The only really extra thing I had to do was screw in the zerk fitting nipple into each of the 4 tie rod ends and fill them with grease once I was done. The Monroe Stabilizer Shock had better reviews than the Moog counterpart, so I gave it a try. Glad I did. Very smooth steering with no adverse jerking of the wheel when I encounter the occasional pothole. The only con is I had to purchase a cover for the exposed rod. SA1997 for about $5. Still cheaper for the pair than the Moog. I can't say the Moog is better or not, just that it was more expensive for about the same kind of reviews. Installation was straight forward and really no problem at all. I did use Deep Creep on all the old rusty bolts a day ahead of time and again about an hour before starting. They came off with little unexpected effort. I assembled the new tie rod ends into the new steering and drag links, then adjusted them to the same overall length of the old rusty ones I pulled off. One bit of advice if you haven't done this before and are going to do it yourself. Remove the old track bar last and install the new track bar first. The axel will shift and it is easier to crank around under your rig without the steering linkage in the way. I used plain old nylon rachet straps (2 of them) to pull the axel back into place to get the 2nd bolt into the track bar. Not hard at all. The sway bar links, steering bar and drag link all went in easy peasy. Torqued everything down to spec, installed the included cotter pins, greased the 4 fittings and drove it to the alignment shop. Took me about 4 hours from set up to clean up...and most of that time was beer, youtube and chatting with my neighbor. You can do this in much less time. It is not a difficult task. I noticed a significant difference in steering right away. Now after a month, it still feels solid and smooth with very little wiggle (less than 1/2 in, was about 2 1/2 inches before) in the steering wheel. I am sure this is from the still stock steering box with 270,000 miles on it. A side note: You may want to consider replacing your ball joints, or having them done, if your tire has wiggle from top to bottom. Mine were still tight and right so I did not replace them, but you'll want to if they're loose. Overall this was a tremendous improvement to my Jeep. Well worth my time and money. I recommend using the Moog brand. Very good value for the price.