Speaker Wall Plate 16 Banana Post and 2 RCA

If you go to a local home improvement place, you are lucky if you find anything similar, in fact I couldn't find it, you could only order them and they were not as complete and they were more expensive. This is a quality product, the only thing missing is a mounting bracket, but those are a couple of dollars and no wall plate ever comes with the mounting bracket. You can either connect the wires via twist and lock or you can use banana type connectors, either way, it works perfectly. I would recommend this for any professional grade home installation, even institutional one. My system is 7.1 so I didn't use the center channels, but that is OK because it wired it for maybe a future expansion. But at it stands it sounds perfect.

Feels solid and I don't notice any reduction in audio quality. Nice that there are so many hookups and it's somewhat modular. Be sure to order a mud ring to install with it.

This worked extremely well for a 7.2 setup. I used this during a basement refinish. I ran the speaker cables post framing. I used a 3-gang low voltage box for mounting it (pre dry wall). Once dry walled, used Sewell banana clips on the back to hook up each cable (and tested them). I hate cables, this really helped to consolidate the massive amount of cabling needed for this setup.

This wall plate is built well and very easy to install and wire. This is a very good solution to concealing your speaker wire and cleaning up the area behind your equipment (receivers, amps etc...) I received it in a timely manner and was not disappointed with the quality of the product.

I like to wall plate but unless you find a "short shaft" banana plug, pushing it in on the front side will push the back side banana plug out. I recommend using either a spade connection or bare wire on the back side. I have been unable to locate "short shaft" banana plugs

Product as described. Works as it should, easy to connect terminated stereo wires to the cover plate. Looks good. Would buy again.

if you know what your doing its great don't blame the product if you don't know how to install

I'm setting up a new AV/home theater system, and needed an elegant way to connect wiring behind our AV credenza with in-wall wiring. This plate and connections has all the speaker connections I need. The only other linkages, and I wish they were available in this format, are (1) COAX, and (2) RJ45 (Ethernet). The latter will have to go in a separate wall plate.

Works well. Just a bit snug fitting all the wires on the back. I did use 10 gauge so a little larger diameter made it more difficult.

My banana plugs fit very loose like they fall out