Bittwee 3PCS Car Brake Piston Wind Back Tool, Rear Pad Rewind

I bought this caliper rewind on a whim because it looked so simple, not to mention it wasn`t expensive. What a pleasant suprise. It`s extremely high quality and so east to use. I have a large set with a bunch of attachments that works but it`s a pain to get all the pieces in place and keep them there long enough to do the job without falling apart. This one snaps together. slips into place and winds the caliper back in seconds. I love it!

Works great for rear brake calipers on my Ford. The only slight issue I had was that the metal backing plate had to be flipped in the opposite curvature of the caliper/pads. Still did what it was intended to do and is a whole lot easier than using needle nose pliers.

I used this on my 2011 Prius to change the back rotors and had to use it to compress the calipers. This tool worked extremely well and could be flipped to fit two different-sized caliper pistons and the pins that fit them, which was very convenient. It worked flawlessly. I had one before by another company, and it would always slip off and wouldn't stay on the caliper piston. This one stayed right on there, made the job so much easier, and the fact that you can flip it for different sizes means it can be used on many different vehicles. I'm impressed

This is a well made tool and does the job. Sort of. I bought it specifically for use on my Pontiac Solstice. The part the has the pins to engage with the piston to screw it in, didn't fit. I have an adjustable caliper tool from Performance Tool that uses a standard 3/8 drive. This Tool has a 3/8 drive (close) for its caliper tool. Unfortunately, its actually larger than 3/8" and didn't fit my adjustable caliper tool. I adjusted the square 3/8" drive with a grinder and made it fit. Without this tool, I many times cannot get the pistons to retract even when turning the piston. With this tool putting some pressure on the piston while turning it, makes all the difference. If I could make some recommendations to make this a 5 star tool they would be, 1) Make the square drive standard 3/8" drive 2) included another piston tool plate to offer more calipers for this tool to work with Quite honestly, those would be the only 2 changes needed.

Received as advertised

I have a 2016 Mazda 3 iSport, it worked for it but with some hassle. The piece that best fit the piston was a bit too large and the tool itself was a bit large to fit between where the pad sits and the piston on the more worn brakes making it somewhat difficult to compress the piston. The part does work and feels solid, but can be hard to use. I've used some that you can rent from part shops and those are considerably easier to use since they have a variety of heads to fit the piston. I would probably recommend spending a bit more to get one of those kits if you plan to change your own brakes regularly.

The listing said it would fir a 2019 chevy equinox but the side that goes on the calipers piston had a three prong design and the tool only has 2 prongs and was unable to use the tool.

Gets the job done. Affordable option.

Great thing. It's just doing the job.

Je suis satisfait

أداة ممتازة جدا فوق الوصف من حيث الخامة والأداء، ما كنت أتوقع أبدا أن تكون بهذه الخامة الممتازة.

Not so good. The one plate bent while using it I ended up using a small c clamp to push back the piston on the caliper. Also using the brake pad as a replacement.

Sold to work with Volvo C30 rear brake... It does not, not without an adaper. The tip does not fit the piston of the galiper of a C30 2008.