Nelyrho 3-Burner Propane Forge Kit with Double Doors, 2600°F Max

Works great. Lots of heat hoses are far enough away they will not get hot or melt

Heat is hard to optimize in this design. Good to learn tough but i would.go.with a smaller one on this type of.frame. also the door are a pain to deal with, heat deform the door making the wool pop out..

This forged arrived early, but it had one broken part. It was one of the ceramic insulating rings where the burners connect. Not only did the manufacturer get back to me in an hour or so. But they sent me 3 new ones that arrived a day or two earlier than they said. Excellent customer support. And, the forge works perfectly. Would buy again.

👍

So far so good but, it uses a lot more gas than my old homemade forge. Also needs some type of air choke. The middle burner on mine huffs and puffs and tries to run the flame back up the tube. I wrapped a piece of a beer can around it and wired it in place where I can slide it up and down and seems to work better with about 1/3 of the opening covered. I'll come up with a more permanent solution. It also needs some ball valves so you can run one, two, or 3 burners to save gas on smaller projects and it only comes with 2 furnace bricks so I bought 4 more so I could put more of them in and cover the whole floor of the forge.