Light Weight PLA Filament 1.75mm LW-PLA Grey 0.8kg Low Density 3D Printing Filament, PolyLite 3D Printer Filament Grey, Print with Most 3D Printers

Les températures d'impression ne sont marquées que sur la boite : reportez les sur la bobine pour ne pas oublier. Le fil est '' rèche '', pas lisse avant impression. La bobine fait 800g pas 1kg, comme prévu.

I always buy from this seller because of the Great quality fast shipping and awesome customer service. Highly recommended

Ne tient pas ses promesses. Il est facile à imprimer mais question poids on gagne environ 25pc par rapport à un pla normal et non 50 pc . J'avais acheté celui-ci pour imprimer un avion rc. Un pla lw (e sun par exemple) est beaucoup plus léger. A déconseiller pour la réalisation de pièces qui doivent être légères.

Ne ormai stampati diversi kg per i miei aerei, un po ostico da stampare, ma quando si è trovato i giusti parametri, stampa bene

Very lightweight, and impressively rigid for its density, you just need to keep a few things in mind: - Print it slow, like no faster than 100mm/s, and ideally around 75mm/s even if your printer can do much faster like mine, keep it slow. - Print at a higher temperature like 225C . - Make sure to calibrate pressure advance (at the correct temp) for this filament specifically. - The filament itself is very brittle but don't let that scare you, the final parts that come out are excellent. - Parts that are somewhat hollow inside will experience a lot of stringing, but all you need is a bit of sandpaper to go over it a few times to smooth out the surface and it'll be just like the outer perimeters. Attached image is a partially finished UAV printed with this material using: - 1 perimeter - 5% infill (gyroid) - 225C nozzle temp, 60C bed temp (PEI) - 0.14mm layer height - 100mm/s perimeters and 20-30mm for bridges, and 50mm/s for supports and top solid infill, gap fill Note the smooth print lines and clean surfaces.